SKU SKU_16397
Handle Bar Straps
£14.95
Handle Bar straps by R&G to stabilise your bike during transporting it. These straps are heavy duty.
1
- Fitment question? Call 01298 816633
- Postage is confirmed by email unless stated. Shipping info
Instructions:
1. Load motorcycle into van/trailer, placing the front wheel against a secure stop.
2. Place machine on side/centre/paddock stand, or get a second person to hold the machine until secure.
3. Grasp the two cuffs, one in each hand and pull apart far enough to slip the cuffs over each grip,being careful not to foul any switch gear or levers.
Pull down on both end loops and attach to your own tie-down hooks, making sure that the anchor points pull down and slightly forward on to the front wheel stop. The tie-down points should always be as far apart as possible t better triangulate the support of your bike.
Note: Additional tie downs are required to secure the rear of the motorcycle.
Warning : The user of the BarStrap assumes full responsibility for determining the safety and suitability of this device and liability is therefore limited to the replacement of the BarStrap if proved to be defective in workmanship or materials.
