The cookie settings on this website are adjusted to allow all cookies so that you have the very best experience. If you continue without changing your cookie settings, we'll assume that you are happy to receive all cookies on our website. However, if you would like to, you can change your settings at any time using the Change cookie settings link in the Special menu.        
Home :: Triumph R&G Spindle sliders

Triumph R&G Spindle sliders

Triumph R&G Spindle sliders
(0 reviews)  

Fitting instructions for Triumph bikes:

Attach one of the nuts and one of the washers to one end of the supplied spindle bar.
Then slide the larger protector along the bar, so that it is up behind the washer, with the nut and washer sunk inside the protector.
Push the spindle bar through the rear wheel spindle hollow, working from brake disc side towards chain side.
Place smaller protector over the exposed end of the bar and over the wheel nut.
Slide the remaining washer onto the bar and then, using your wrench, attach the remaining nut to the end of the bar.
Place appropriate sockets/wrenches over both ends of the bar and tighten so that equal amounts of bar are seen at each end.
Tighten until the assembly locks up. Do not overtighten – the nyloc nuts will hold it tight.

Price: £29.99 (32.99)
: *
: *
: *
Type the characters you see in the picture:

There have been no reviews